ARDUINO UNO WIFI REV2

Features

Add this card to a device and you can connect it to a WiFi network using its secure ECC608 cryptographic chip gas pedal. TheArduino Uno WiFi is functionally the same as theArduino Uno Rev3, but with the addition of WiFi and other improvements. It incorporates a brand new 8-bit microprocessor from Microchip and has an integrated IMU (inertial measurement unit). The Wi-Fi module is a standalone SoC with a built-in TCP/IP protocol stack that can provide access to a Wi-Fi network or serve as an access point. TheArduino Uno WiFi has 14 digital input/output pins - 5 can be used as PWM outputs with pin 11 not being PWM like on the UNO Rev3 -6 analog inputs, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller. Simply connect it to a computer with a USB cable or power it with an AC adapter or battery to get started.

• Microcontroller ATmega4809

• Memory ATmega4809 6KB SRAM, 48KB flash, 256 bytes EEPROM

• Clock speed ATmega4809 16 MHz processor

• Connector USB-B

• 25-pin integrated LED

• x14 Digital I/O pins

• x6 Analog Input Pins

• x5 PWM Pins

• Connectivity Nina W102 uBlox Bluetooth® Module

• Nina W102 uBlox Wi-Fi Module

• Wi-Fi Security ATECC608A

• LSM6DS3TR IMU Sensors

• UART communication

• I2C

• SPI

• I/O supply voltage 5V

• Input voltage (nominal) 6-20V

• Continuous current per I/O pin 20 mA

• Power connector Plug

• Compatible with : ARDUINO 4 RELAY SHIELD, ARDUINO MOTOR SHIELD REV3

• Weight: 25 g

• Dimensions: 68.6 mm x 53.4 mm

Please note: Pin 11 is not PWM enabled and on some batches, connector is incorrectly marked. The available PWM pins are: 3, 5, 6, 9 and 10.

Programming

To program with Arduino, you can use the open-source software platforms ofArduino: