Category: Electronic components

Batch of 200 electrolytic...

Pack of 200 aluminum electrolytic capacitors Suitable for a wide range of electronic applications requiring a cost-effective high-capacity solution

Set of 20 electrical screw...

Useful to connect your wires together Set of 20 electrical screw terminals with 5.08 mm connector

Sliding potentiometer module

Sliding potentiometer module for adjusting electrical resistance using the slider Easy adjustment: with this sliding potentiometer, you can easily adjust resistance by simply sliding the slider along the track in real time. Often used in projects involving volume control, brightness,...

Batch of 600 NPN - PNP transistors

Complete box of 600 transistors Includes all transistors used in circuit design 15 models of transistors

Batch of 300 ceramic capacitors...

Suitable for a wide range of electronic applications requiring a cost-effective high-capacity solution 300 electrolytic capacitors of 10 values 10 values: 10pF, 20pF, 30pF, 47pF, 56pF, 68pF, 100pF, 1nF, 10nF, 100nF 30 pieces of each value

5m roll of Jumper Crimp Cables

5m roll of jumper wire to be crimped 20 pins Tinned Copper Wire Suitable for 2.54mm plugs - Slot: 1.27mm

Box of 140 jumpers for Breadboard

Kit of 140 Riders composed of 14 Kinds of each Color: red, orange, yellow, green, blue, purple, gray, brown, white. size : (mm): 2, 5, 7, 10, 12, 15, 17, 20, 22, 25, 50, 75, 100, 125

Male GPIO Adapter for Raspberry...

Solder GPIO adapter for Raspberry Pi Zero Ideal for connecting your extensions and modules or for prototyping 20 male pins Available in 1x20 or 2x20 pin versions

GPIO 2x20 adapter

This adapter male 2x20 pin adapter adapter is a great way to add PINs to your pINs to your Raspberry PI 0 or prototyping board. Requires soldering.

2 to 12 pin flat dial switches...

Right Angle HDMI Adapter

Making custom HDMI cables has never been easier. Simply grab one of our HDMI ribbon cables, then swap and fit one of our HDMI adapters to each end using the flexible cable clips. There are so many options!

Light sensor

CdS cells are small light sensors. As the cell is exposed to more light, the resistance decreases. The resistance range is about 5-10KΩ, when it is dark, and goes up to 200KΩ. To use, connect one side of the photo cell to the power supply (e.g. 5V) and the other side to the analog input pin of...

Potentiometer

These are our favorite mini potentiometers, perfect for breadboarding and prototyping. They have a long grippy knob and with 0.1" spacing they plug into breadboards or perfboards with ease. TECHNICAL DETAILS Body size: 9.5mm x 9.5mm x 4.9mmRotation: 270 degrees

Analog to digital converter

The MCP3008 is a 10-bit successive approximation analog-to-digital converter with an integrated sample-and-hold circuit. It is programmable to provide four pairs of pseudo-differential inputs or eight single-ended inputs. ........

DC Female to 2.1mm jack adapter

If you need to connect a DC power supply to a board that doesn't have a DC Jack port, this adapter will come in handy! There is a 2.1mm DC jack on one end, and a screw terminal on the other. The terminals are marked with positive/negative signs.