Nano base board for Raspberry Pi Compute Module 4

Contents

• Nano 1 card for CM4

• 2*20PIN color-coded GPIO header

Features

• Nano A base board

• Compatible with Compute Module 4

• USB 2.0 port

• CSI-2 PIP port (15-pin 1mm FPC connector)

• MicroSD card slot(for connecting a Micro SD card with pre-burned image - Lite variant ONLY)

• 5V/2.5A power supply via USB-C port

• USB-C port can be used for eMMC burning

• BOOT switch

• PWR indicator showing CM4 power status

• ACT indicator showing CM4 operating status

• Input power: 5V

• Dimensions: 55 x 40 mm

Warning: Compute Module 4 is not included.

Precautions for use

1. DO NOT plug and unplug any device other than USB when powered.
2. The module does not have a protection circuit, take all precautions by not shorting the power supply.
3. USB2.0 is disabled by default, if you want to open it, you have to add the following line: dtoverlay=dwc2,dr_mode=host to the config.txt file