PHAT Maker for Raspberry Pi Zero WH

Contents

• PHAT Maker

• Stacking header 2x20

Features

• Same size as the Raspberry Pi Zero board

• x4 aligned mounting holes

• x3 programmable pushbuttons (GPIO 21, 19, 20)

• LEDs for pins (GPIO 17, 18, 27, 22, 25, 12, 13, 19)

• Active buzzer (GPIO 26)

• Buzzer

• Label for all GPIOs including SPI, UART, I2C, GND

• Input voltage: USB 5 V (USB Micro-B)

• USB to UART (FT231X)

Maker pHAT is compatible with :

• Raspberry Pi Zero V1.3 (you will need to solder a 2x20 header pin, not included)

• Raspberry Pi Zero W (you will need to solder a 2x20 header pin, not included)

• Raspberry Pi Zero WH (ready to plug in and use)

• Raspberry Pi 1 A+ model (requires 2x20 stacking header)

• Raspberry Pi 3 A+ model (requires 2x20 stacking header)

• Raspberry Pi 3 model B (requires 2x20 stacking header)

• Raspberry Pi 3 model B+ (requires 2x20 stacking header)

• Raspberry Pi 4 model B 1 GB (requires 2x20 stacking header)

• Raspberry Pi 4 model B 2 GB (requires 2x20 stacking header)

• Raspberry Pi 4 model B 4 GB (requires 2x20 stacking header)