The power module is specially designed for the Raspberry Pi 3 Model B, allowing the motherboard to run offline for up to 9 hours. It's not just a power supply for Raspberry Pi; this board has 2 USB Type A ports - one provides power for the Raspberry Pi and the other for the built-in LCD.The...
Easily use your Raspberry cameras This adapter is designed to easily use Raspberry Pi Zero cameras with the full size Raspberry Pi. To easily use your camera, simply insert your camera's cable into the connector and then connect it to the CSI connector on your PI.
Increase the capabilities of your Raspberry Pi The original Raspberry Pi has only one UART port with 1 channel. With this serial extension, you have a UART with two channels as well as 8 GPIOs programmable via I2C. The LEDs integrated in the extension allow you to monitor the UART operating status.
Contents of the kit : Breadboard 730 points SYB 120 65 male-to-male jumper cables
Need large LED indicators? Here are the 10mm diffuse tint LEDs. They are bright enough to be seen in the daytime, and from all angles. They easily fit in a breadbord. diameter 10mmwavelength 565 nm2.2-2.5V voltage, current 20mA1000 mcd typical brightness
Polystyrene Case for Raspberry PI Camera Board Black, White, Transparent or Carbon No screws, no glue, just clip the camera. Everything is pre-cut. Wall mounting possible. Available in transparent, white and carbon.
The ProtoZero is a breadboard prototyping kit for the Raspberry Pi 0, it was designed to make it easy to move your breadboard to a PCB. Just add your components to the prototyping area, connect GPIO, power and GND if needed - solder it all together and you will go far!
Français
Español
Italiano
Deutsch
